Workpiece material / Wood (router)

Hardwood (oak, maple, walnut) speeds and feeds

Starting router chip loads for Hardwood (oak, maple, walnut). Each value below links to the published chart it rests on, and anything that is our own pick or single-source is marked estimated, so you can re-verify it yourself. Starting points, not limits.

Chip-load driven, not surface-speed driven: set your spindle RPM (routers typically run 12,000-24,000) and the feed is RPM × flutes × chip load. These chip loads are published router-chart starting points and vary up to about 2x between makers - tune by feel. If the wood burns, feed FASTER (take a bigger chip), do not slow down. Power, torque and deflection are calibrated for metal and are not shown for wood.

Cutting data / sourcedClick any source to check
ValueUsedProvider readings (each linked)
Chip load @ 0.25" (estimated) 0.0100 in/tooth
Chip load by end-mill diameter in/tooth
0.125"0.25"0.5"
0.00400.01000.0200

Notes

CNC-router chip loads for solid hardwood (Janka roughly 1,000-1,500 lbf: black walnut ~1,010, northern red oak ~1,290, hard maple ~1,450). Router guidance is chip-load + RPM based, NOT surface-speed based, so no SFM is published or shown. Chip load scales primarily with tool diameter; species/Janka barely moves it (carbide is far harder than any wood), so a single "hardwood" band covers the common species. Shipped values are the midpoints of the widely-used CNC router chip-load chart (as published by Cutter Shop). These numbers circulate widely in the router community but we could not verify them against a primary tool-maker source, so they are flagged estimated and attributed to no single manufacturer. The chart is very likely Vortex Tool's own: CNCCookbook lists Vortex's router material columns, and they are the chart's ten columns in the same order, and its quoted Vortex figure (1/2 in plywood, .021-.023 in/tooth) is the chart's cell. That is one lineage, not a second witness. Chip load varies more with bit geometry than with maker, and downcut or specialty bits run lower. Starting points to tune per machine, bit and finish; depth of cut assumed no greater than tool diameter.

Verify this yourself

Every number above links to the provider that publishes it. Open two or more and confirm they agree with what is shown here. Full source list:

Take these into the feeds and speeds calculator for RPM, feed and power. Start a little under these numbers on a light or flexible setup.