Workpiece material / Wood (router)
MDF / Particleboard speeds and feeds
Starting router chip loads for MDF / Particleboard. Each value below links to the published chart it rests on, and anything that is our own pick or single-source is marked estimated, so you can re-verify it yourself. Starting points, not limits.
Chip-load driven, not surface-speed driven: set your spindle RPM (routers typically run 12,000-24,000) and the feed is RPM × flutes × chip load. MDF and particleboard actually take the HIGHEST chip loads of the wood group despite not being hard. These are published router-chart starting points that vary between makers - tune by feel; if the edge burns, feed FASTER. Power, torque and deflection are metal-calibrated and are not shown for wood.
| Value | Used | Provider readings (each linked) |
|---|---|---|
| Chip load @ 0.25" (estimated) | 0.0145 in/tooth |
|
| 0.125" | 0.25" | 0.5" |
|---|---|---|
| 0.0055 | 0.0145 | 0.0260 |
Notes
CNC-router chip loads for MDF and particleboard (engineered panels, so Janka does not apply). MDF and particleboard share a band, and it takes the highest chip loads of the three wood groups. Guidance is chip-load + RPM based, NOT surface-speed based, so no SFM is published or shown. Shipped values are the midpoints of the widely-used CNC router chip-load chart (as published by Cutter Shop); these circulate widely but are not verified against a primary tool-maker source, so they are flagged estimated and attributed to no single manufacturer. MDF dust is abrasive and a lung hazard - use dust extraction. Depth of cut is assumed no greater than tool diameter.
Verify this yourself
Every number above links to the provider that publishes it. Open two or more and confirm they agree with what is shown here. Full source list:
Take these into the feeds and speeds calculator for RPM, feed and power. Start a little under these numbers on a light or flexible setup.