Workpiece material / Wood (router)
Softwood / Plywood (pine, fir, birch ply) speeds and feeds
Starting router chip loads for Softwood / Plywood (pine, fir, birch ply). Each value below links to the published chart it rests on, and anything that is our own pick or single-source is marked estimated, so you can re-verify it yourself. Starting points, not limits.
Chip-load driven, not surface-speed driven: set your spindle RPM (routers typically run 12,000-24,000) and the feed is RPM × flutes × chip load. These chip loads are published router-chart starting points and vary up to about 2x between makers - tune by feel. If the wood burns, feed FASTER (take a bigger chip), do not slow down. For plywood and laminate a compression bit gives clean top and bottom faces. Power, torque and deflection are metal-calibrated and are not shown for wood.
| Value | Used | Provider readings (each linked) |
|---|---|---|
| Chip load @ 0.25" (estimated) | 0.0120 in/tooth |
|
| 0.125" | 0.25" | 0.5" |
|---|---|---|
| 0.0050 | 0.0120 | 0.0220 |
Notes
CNC-router chip loads for softwood and plywood (softwood Janka roughly 350-900 lbf: eastern white pine ~380, southern yellow pine ~690-870). Softwood and plywood share a band - the solid-vs-sheet distinction matters more to chip load than species does. Router guidance is chip-load + RPM based, NOT surface-speed based, so no SFM is published or shown. Shipped values are the midpoints of the widely-used CNC router chip-load chart (as published by Cutter Shop); these circulate widely but are not verified against a primary tool-maker source, so they are flagged estimated and attributed to no single manufacturer. Vortex (via CNCCookbook) lists 1/2 in plywood at .021-.023 in/tooth, the same as the chart's cell around our .022, but this is not an independent check: the chart's ten material columns are Vortex's own list in the same order, so it is very likely Vortex's chart republished. Starting points to tune per machine, bit and finish; depth of cut assumed no greater than tool diameter.
Verify this yourself
Every number above links to the provider that publishes it. Open two or more and confirm they agree with what is shown here. Full source list:
Take these into the feeds and speeds calculator for RPM, feed and power. Start a little under these numbers on a light or flexible setup.