Sourcing dossier
Source for wood data
Quick dossier about how we sourced and checked the data for the wood router feeds and speeds. If you find any discrepancies, please let us know via the Report a bug button.
The sources we used
The chip loads come from the widely-used CNC router chip-load chart, as published by Cutter Shop. These numbers circulate across the router community; the chart itself carries no attribution, and we could not verify it against a primary tool-maker source, so every wood value is flagged estimated and attributed to no single manufacturer.
- Chip load by material and tool diameter (the shipped numbers): Cutter Shop router chip-load chart.
- Independent cross-check: Vortex Tool numbers at CNCCookbook. Their published 1/2 in plywood figure, .021-.023 in/tooth, is identical to the chart value we ship for that size (.022), consistent with Vortex's published range. The identical figures may share industry lineage, so treat that as corroboration, not fully independent verification. Chip load also varies with bit geometry (downcut and specialty bits run lower), so tune to your specific tool.
- Janka hardness context: PreciseBits relative hardness table.
Every wood material page lists its own sources with the same links, so you can open the original and check the shipped value against it: hardwood, softwood and plywood, MDF and particleboard.
Note about surface speed
Manufacturer wood-routing data is based on chip-load plus RPM, not on surface speed. For wood, the surface speed is not the limiting factor. This means we can't use SFM to force wood into a metal calculator. Instead the feeds and speeds tool switches to a spindle-RPM input when you pick a wood and computes the feed directly, with no invented surface speed and no RPM derived from one:
Validation
- Cross-checked where we can. Each shipped chip load is the midpoint of the published chart's range. At the one size where a second maker's number overlaps, they agree exactly: Vortex lists 1/2 in plywood at .021-.023 in/tooth, matching the chart. Everywhere else the chart is the only witness, which is why every value is flagged estimated.
- Flagged as estimated. Every wood chip load is marked as an estimate on its page. It is a starting-point range, not a precise physical constant.
- Machine-checked. A validator gate holds each value inside a reasonable physical range,
unit tests pin the expected shape (chip load rises with tool diameter, and MDF and particleboard
sit at or above softwood, which sits at or above hardwood), and a frozen regression vector locks
the arithmetic so this number can never silently drift:
feed = 18,000 × 2 × 0.010 = 360 in/min
What we do not claim
Species and Janka hardness barely move chip load, because carbide is far harder than any wood. This means that a single hardwood band covers oak, maple, walnut and similar woods. These values are starting points to tune to your own machine, bit and finish, not limits. Note about the classic wood mistake: if it burns, feed faster and take a bigger chip, do not slow down. These calculators are for planning and as a starting point. Recommended speeds and feeds are published starting values that vary with your specific tool, coating, machine rigidity, workholding and coolant. Always start conservative, listen to the cut, and follow your tool maker data sheet.
Need a break from the numbers? Grow a bonsai in your browser
(my game) ·
Wishlist on Steam